Fluid handling, regulation and control

Fluid handling, regulation and control

Fluid handling, regulation and control

VIKING General purpose – Internal gear pumps



The Viking General Purpose Series 32 pumps are extremely well suited for light, medium and intermittent service handling a variety of liquids. The smaller sizes “C”, “F” and “FH” are constructed for heavier duty service. Mechanical seal equipped General Purpose pump models in sizes from “C” thru “HL” shown in this section are available with Underwriters label for handling fuel oil. Model numbers for these pumps must be designated by a suffix -X. “UL” listed models can be equipped with integral relief valve. The additional sizes of unmounted General Purpose pumps are illustrated on the following page. Also for continuous service and for handling viscous liquids, see Viking’s line of heavy duty pumps, Section 630. Viking’s unique and unusually simple pump construction makes it adaptable to many diversified installations.

The Viking General Purpose Series 32 pumps possess excellent vacuum characteristics and will operate and prime at suction lifts up to 25 feet, depending upon the vaporization point of volatile liquids. Because of the cushioned action in providing a continuous and steady stream of liquid without splashing, pounding, foaming or churning, the Viking pump is adaptable to an unlimited number of industrial applications.

All sizes of Viking General Purpose pumps have tapped ports except “LQ”, “LL”, “Q”, “M” and “N” sizes. These have flanged ports ready to accept companion flanges. “K” through “N” sizes are furnished with conventional packing as standard. A cartridge style triple lip sealing option is available for the “K” through “N” sizes, contact the factory for details. A supporting anti-friction bearing pillow block is recommended for the end of the pump shaft on all V-belt driven units.


  • Max. Capacity: 450 GPM (102 M³/hr)
  • Max. Pressure: 250 PSI (17 BAR)
  • Max. Viscosity: 250,000 SSU (55,000 cSt)
  • Temperature Range: -60°F to +450°F (-50°C to +232°C)
  • Sealing / Coupling: Packing, Component Mechanical Seal (C-HL)
  • Porting: Opposite (180°), Right Angle (90°), Same Side, NPT/BSP, Flanged
  • Mounting: Foot Mount


  • Simplified rotor retention system, economical for medium duty applications.
  • Back pull-out seals provide access without disturbing the wet end.
  • Long shaft standard for pillow block and belt drive, or reducer drive.
 Chiama  :
Scrivici :